Dear Kevin,

I am currently beginning my first boat wiring project, a total rewire of a small Owens cruiser from the late ’60s.

Here’s my problem:

The old wiring runs behind the original paneling and headliner. I could try dismantling everything to remove and replace the wires, but am concerned about damaging any of the woodwork. It’s old. It’s gorgeous. It would be a bitch to replace.

I don’t mind leaving the old wiring in place and just running a new harness, but that still leaves the problem of installing the new wires without causing any damage.

Any ideas?

RP

Dear Ron,

Your problem was common with boat restoration projects – until the introduction of Harness in a Can.

Harness in a Can lets you spray pro-quality boat wiring into even the most hard to reach areas. Simply point, spray, and apply power. What could be easier?

And, it’s not just easy, it’s ABYC approved! Harness in a Can sprays out a harness with correct wire color and sizing – and with all of the connections that you need to get the job done fast.

If you order now, you will also receive a cap snaffler – absolutely free. Cap snafflers snaffle caps off any size jug, bottle or jar…and they really really work.

Call now to order. The toll free number is 877-277-3665. Operators are standing by. That’s 877-APR-FOOL.

Kevin.